Jump to content

Recommended Posts

It would be most beneficial, for us 'novice' first time users of your products, if you could show screenshots of the settings on devices on both ends, of each of these modes.

On the downstream devices, while in a 'Bridge' mode, does my PC / LAN switch / LAN access point, plug into the LAN port on the POE, or on the second LAN port on the bridge device?

Share this post


Link to post
Share on other sites

Hi Tomowa! Thanks for viewing and please excuse my delay.

I'll try to get some screen shots up for everyone. 

The remote device needs to be using the primary port, labeled "LAN(PoE)" for at minimum power. That port is the primary port and can be connected to either the PoE Injector that comes with the package OR to a PoE switch that is ultimately connected to the LAN/PC. Connecting the primary port on the remote end to your LAN is suggested method.

The secondary port can be used to power and send data to an 802.3af compliant device like IP Camera/Access Point.

 

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.