Jump to content
Sign in to follow this  
Nicholas Vettel

Compliance Band2 on EnStationAC

Recommended Posts

Since upgrading to the latest v2.0.102, my EnStationAC can not have the stable connection with WDS link at compliance band2. May EnGenius team assist on this for further verification?

Share this post


Link to post
Share on other sites
Do you have a pair of similar platform? Is it for Point to point/multipoint deployment? rhinox27 is correct to ensure that your equipment is up to date and perform a reset after the update.

One thing that you may also try, is changing the channel frequency and power settings of the bridges. Below are the applicable channels that you may try.

The following five 80 MHz channels are legitimate to use for both indoor and outdoor deployments with 802.11ac APs and point-to-(multi)point with the EnStationAC:

-          36 (36-48) [entire UNII-1 band]
-          52 (52-64) [entire UNII-2 band]
-          100 (100-112) [lower 1/3 of UNII-2e band]
-          116 (116-128) [middle 1/3 of UNII-2e band]
-          149 (149-161) [entire UNII-3 band]


The following eleven 40 MHz channels are legitimate to use for both indoor and outdoor deployment with 802.11n APs and point-to-(multi)point with the EnStation5:


-          36 (36-40) [lower half of UNII-1 band]
-          44 (44-48) [upper half of UNII-1 band]
-          52 (52-56) [lower half of UNII-2 band]
-          60 (60-64) [upper half of UNII-1 band]
-          100 (100-104)  [lower 1/6 of UNII-2e band]
-          108 (108-112)  [1/6 of UNII-2e band]
-          116 (116-120)  [1/6 of UNII-2e band]
-          124 (124-128)  [1/6 of UNII-2e band]
-          132 (132-136)  [1/6 of UNII-2e band]
-          149 (149-153) [lower half of UNII-3 band]
-          157 (157-161) [upper half of UNII-3 band]

 
Set the base TX power settings to 20dBm.
Hope the above helps:-)
Edited by laireV
  • Upvote 2

Share this post


Link to post
Share on other sites

Hi 

    If you would like to implement WDS under 5GHz radio, we suggest you to perform it under Non-DFS channels for assuring always connection.

On 2016/6/27 at 2:41 PM, Alijalali said:

You can try different channels but don't use DFS channel for WDS link.

 

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
Sign in to follow this  

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.