Jump to content

Search the Community

Showing results for tags 'site survey failure'.

More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • General Discussion
    • Business Talk
    • What's Up
  • Neutron
    • Neutron Wireless
    • Neutron Switch/ Controller
    • AP Camera
    • ezMaster Software
    • New Ideas
  • Electron
    • Electron & Neutron Differences
    • Electron Outdoor Wireless
    • Electron Indoor Wireless
    • Electron Switch
    • New Ideas
  • Antennas
    • Antennas
    • New Ideas
  • Long Range Phone System
    • DuraFon series
    • FreeStyle Series
    • New Ideas
  • Router/ Gateway
    • Cloud Router
    • New Ideas
  • Surveillance
    • IP Camera
    • Video Management System
    • New Ideas
  • Mobile APPs
    • Router APPs
    • Camera APP
    • New Ideas
  • Other Products
    • Power Accessories
    • USB Adapter & Repeater
  • Knowledge Base Collection ( F.A.Q Format )
    • Getting Started
    • Configurations
    • Monitoring & Management
    • ezMaster


There are no results to display.

There are no results to display.

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start



About Me


Found 1 result

  1. I'm new to building links, and perhaps what I'm trying to do is not possible with the ENH500. Please excuse my ignorance. The attach image shows a sketch of the envisioned system configuration. I have successfully logged into the control panel of the ENH500 from my laptop computer, selected bridge mode, and requested a "site survey" as shown on page 4-24 of the ENH500 manual. My problem .. the ENH500 does not find the 5 G Hz signal being broadcast by the Time-Warner Ubee DVW32CB modem even if given many minutes to perform the search. I know that the Ubee DVW32CB modem is broadcasting a 5 G Hz signal because I can use it to connect my iPhone to the Internet. When I log into the control panel of the DVW32CB modem, it shows my iPhone as being connected via the 5 G Hz link (see attached "access"). The Ubee DVW32CB modem is set to use "Radio wireless channel 153/80 " and MAC access control is disabled. The ENH500 was set for sensitivity = maximum distance; in fact, it was within inches of the DVW32CB modem. I am not sure the ENH500 can be configured as I have envisioned, but I would think that it would indicate the presence of the 5 G Hxz signal. What am I doing wrong? all help is appreciated. If you want to respond directly, send messages to [email protected] Michael
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.