Jump to content

Search the Community

Showing results for tags 'osn7500'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • General Discussion
    • Business Talk
    • What's Up
  • Neutron
    • Neutron Wireless
    • Neutron Switch/ Controller
    • AP Camera
    • ezMaster Software
    • New Ideas
  • Electron
    • Electron & Neutron Differences
    • Electron Outdoor Wireless
    • Electron Indoor Wireless
    • Electron Switch
    • New Ideas
  • Antennas
    • Antennas
    • New Ideas
  • Long Range Phone System
    • DuraFon series
    • FreeStyle Series
    • New Ideas
  • Router/ Gateway
    • Cloud Router
    • New Ideas
  • Surveillance
    • IP Camera
    • Video Management System
    • New Ideas
  • Mobile APPs
    • Router APPs
    • Camera APP
    • New Ideas
  • Other Products
    • Power Accessories
    • USB Adapter & Repeater
  • Knowledge Base Collection ( F.A.Q Format )
    • Getting Started
    • Configurations
    • Monitoring & Management
    • ezMaster

Blogs

There are no results to display.

There are no results to display.


Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


About Me


Country

Found 1 result

  1. Issue Description There is one Ethernet service between two NEs (OSN7500 having software version of 5.21.18.53). Service type is Ethernet Line Service of 2Mbps. Moreover there is configured SNCP between two different lines on SDH layer to protect 2Mbps Ethernet Line Service in case of dual fiber break. The SNCP service is configured NON-Revertive for beow topology. NE1-NE2-NE3-NE4 (Working path) NE1-NE5-NE6-NE4 (Protection path) Alarm Information ALM_GFP_dLFD VCAT_LOA VCAT_LOM_VC12 LP_SLM_VC12 Handling Process After switching the service on NE4 to 'Working Channel' by SNCP Service Control, alams were cleared at the same time. Now the SNCP state becomes consistent and no service alarms are present. Root Cause Below points were ensured during troubleshooting and found normal in status 1) The SNCP status was normal for both NE1 and NE4 2) Traffic was not down during these alarms 3) No switching was present for the Ring and SNCP Later it was found that SNCP service was running on 'Working Channel' on NE1 and 'Protection Channel' on NE4 due to which the trail was showing alarms. Which means that SNCP state was inconsistent. Moreover the traffic was not down during these alarms. Suggestions Always make sure that SNCP is in consistent state for both NEs where it is created. Otherwise the signal label to be received at local station is inconsistent with that to be transmitted at the opposite station.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.