Jump to content

Search the Community

Showing results for tags 'ip address'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • General Discussion
    • Business Talk
    • What's Up
  • Neutron
    • Neutron Wireless
    • Neutron Switch/ Controller
    • AP Camera
    • ezMaster Software
    • New Ideas
  • Electron
    • Electron & Neutron Differences
    • Electron Outdoor Wireless
    • Electron Indoor Wireless
    • Electron Switch
    • New Ideas
  • Antennas
    • Antennas
    • New Ideas
  • Long Range Phone System
    • DuraFon series
    • FreeStyle Series
    • New Ideas
  • Router/ Gateway
    • Cloud Router
    • New Ideas
  • Surveillance
    • IP Camera
    • Video Management System
    • New Ideas
  • Mobile APPs
    • Router APPs
    • Camera APP
    • New Ideas
  • Other Products
    • Power Accessories
    • USB Adapter & Repeater
  • Knowledge Base Collection ( F.A.Q Format )
    • Getting Started
    • Configurations
    • Monitoring & Management
    • ezMaster

Blogs

There are no results to display.

There are no results to display.


Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


About Me


Country

Found 3 results

  1. My system and all AP's are working fine. The only issue is that the Hostname and IP address do not show for some devices. Example, we have 86 Honeywell thermostats. ABout half of the show the hostname and ip of the device. The remaining are connected and communicating but do not show any Hostname or IP address in the client list. All are on the same VLAN and the exact same model and firmware. No firewall policies or switch policies that would affect the vlan. Also all firmware is up to date Any Thoughts, Thx in advance
  2. Using ENH202 to service a back lot and several small produce storage areas with sliding doors that allow signal to radiate into the coolers. System was working 100% until recently when we lost the AP's Wi-Fi signal. Removed the AP to our bench and connected to our 192.168.1.xxx network for testing. Using our shop POE injector we do have Wi-Fi signal again so we may have a PS issue at the site. Strangely enough we could still access the router GUI via the LAN connection when the Wi-Fi was missing!? Device IP is 192.168.2.xxx BUT we are seeing that it is using our in-house DHCP server to issue addresses on the Wi-Fi in the range of 192.168.1.xxx. Trying to understand how the device is able to communicate with our server across the 192.168.1.xxx LAN with the current 192.168.2.xxx IP address. Seems the AP should not know anything about our local DHCP server. Tech says the device is a bridge but we are running AP mode and on a completely different network. Anyone able to elaborate?
  3. When I connect to my ENH500 with my laptop via the LAN port on the POE injector, the IP address issued to my laptop is 169.254.122.52. This is true of both units in my ENH500 kit. The IP address should be 192.168.1.???. When I run ipconfig through the command prompt, I get no default gateway, so I don't know how else to access the ENH500. Thanks in advance for your help.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.