Search the Community
Showing results for tags 'enh200'.
Found 3 results
So. no support - eesh. the user community is all we get? I've sent email to Engenius and gotten no reply, hoping someone here can help - I have 2 Enh202's that are modified as OEM products for DoorKing. The IP info is set to DHCP and I need to login and change them to hardcoded for obvious security reasons. DoorKing has no idea what the Login user/pass is for their units and referred me to Engenius. (It amazes me that Doorking doesn't know this info). I'm looking for the default login info the the HTTP/web interface of these units so I can program them. Anyone? I've tried the obvious - admin/admin, admin / last 4 of the SN, admin / 9999, admin / 1731, admin / 7396. These are google search results - mainly for Doorking SW and keypads but none work regardless. I'll give this post a few days and be hopeful - otherwise i'll need to find another solution - this project is supposed to be done on the 26th. FYI - these units have a VOIP ATA interface on them, which allows the phone line from the house to the gate (about 1/2mile) to function. The inground / trenched phone line has gone bad.
I have used a pair of ENH200 AP units for several years. Now I am experencing connectivity problems. The link list shows up but my router can't connect to internet. this is my setup. cable modem connected to Router that serves the ip addresses. ENH200 connected to router in WDS Bridge mode. on the other end the other ENH200 is set up as WDS Bridge mode. I then had a router that was an AP. Which port do I plug in the ENH200 to the router. The Wan port or a Lan port? This was working for several years but now has quit. I changed routers but still no dice. The RSSi is around -77 or higher. Should I trim some trees to try to increase signal stength? What IP addresses should I use. the first ENH200 is 192.168.0.2 and the second is 192.168.0.3. The gateway is 192.168.0.1. These are static addresses. What should my router be set to. 192.168.0.9 (Which is open) with a gateway of 192.168.0.1? have spent the last two days trying to fix. David
Question: What is the max length of the Ethernet cable from the PoE injector to the AP/Bridge? Answer: · The maximum distance you can power a device will vary depending on the access point and its voltage required, as well as the voltage provided by the power supply, and the quality of the cable. Cat6 cable is recommended for long POE runs. · 48V 802.3af standard POE can usually go about 100 meters/300 feet.