Jump to content

hansdg1

Public
  • Content Count

    4
  • Joined

  • Last visited

Community Reputation

0 Neutral

About hansdg1

  • Rank
    Newbie
  1. Unfortunately no. I keep hoping that EnGenius will reply with a solution.
  2. Can anyone else verify that they're seeing this behavior?
  3. I think I found where the problem is. Here are snippets from /etc/config/snmpd for both models. On the EAP1200H, it clearly shows that the sysName is set to EAP1200H -- instead of being the Device Name EAP1200H config 'system' 'snmpv2' option 'sysName' 'EAP1200H' option 'sysDescr' 'Wireless Access Point' option 'SnmpTrapDstIP' '' option 'SnmpTrapCmnty' 'public' option 'SnmpTrapDstPort' '162' option 'sysContact' '[redacted]' option 'sysLocation' '[redacted]' option 'SnmpEnable' '1' EAP600 config 'system' option 'sysDescr' 'Wireless Access Point' option 'SnmpTrapDstIP' '' option 'SnmpTrapCmnty' 'public' option 'sysName' 'AP1 (Basement)' option 'sysContact' '[redacted]' option 'sysLocation' '[redacted]' option 'SnmpEnable' '1'
  4. Both of my EAP1200H access points aren't returning the correct Device Name when polled over SNMP. Instead of returning the configured Device Name ("AP3" or "AP4"), they return: SNMPv2-MIB::sysName.0 = STRING: EAP1200H (or with numeric OIDs) .1.3.6.1.2.1.1.5.0 = STRING: EAP1200H I should mention that I also have 2 other EAP600 APs and they are returning the correct Device Name for i in {20..23}; do snmpwalk -v2c -c public 192.168.10.$i SNMPv2-MIB::sysName.0; done SNMPv2-MIB::sysName.0 = STRING: AP1 (Basement) SNMPv2-MIB::sysName.0 = STRING: AP2 (1st Floor Hallway) SNMPv2-MIB::sysName.0 = STRING: EAP1200H SNMPv2-MIB::sysName.0 = STRING: EAP1200H The EAP1200H APs are running firmware version 2.0.197 (The EAP600 APs are running firmware version 1.6.50)
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.